BlackTop Driveway Crack & Joint Repair Tape 33 ft x 1" Wide Permanent Torch-On

Description

RECOMMENDED PRODUCT - DOT APPROVED
FAST AND EASY TO USE - AND A PERFECT PERMANENT REPAIR
LOWEST WORLDWIDE PRICE - 33ft ROLL OF STICK-DOWN & BURN-ON PERMANENT REPAIR TAPE FOR ONLY PER FOOT !!
Black top, Tarmac, Asphalt and Concrete Permanent Repair Tape, "burn-on" to seal re-instatement works and repair cracks, torch-on application prevents the ingress of water and extends the life of the repair without the time needed to melt pots of bitumen. High quality bitumin
permanent
repair tape,
open to traffic in 10 minutes
INSTRUCTIONS -
Sweep the area clean from dust and water, (apply torch beforehand to dry any wet areas) stick tape across the joint removing the separation layer as you go. Lightly torch over the tape to melt it into the jointed line, (kiln dried sand or grit can be sprinkled onto the hot tar joint if additional "non-slip" is needed), The joint will then be waterproof and "welded" together for a long lasting repair.
Melts quickly, faster than other brands, uses less gas and seeps into the join more easily to improve the "weld" and dries harder & stronger in about 10 mins.........
Can also be stuck upright to the cut edge of new laid tarmac to guarantee a sealed joint.
This tape is supplied in 33ft long rolls  OUR 1" wide  is the best for long trench reinstatements and is trafficable within a few minutes after completion, AND IT'S THE LOWEST WORLDWIDE PRICE PER FOOT.
A polymer modified bituminous strip for use as an instant waterproof overbanding seal for small cracks or reinstatement joints up to 1/4 inch wide. For use on both road pavements and secondary roads. The application of the tape prevents the ingress of water which causes cracking and severe fretting leading to the eventual breakdown of the asphalt pavement. The skid resistance can be increased by covering the tape with granite dust or kiln dried sand during torch on procedure,
providing
a surface value similar to that of the existing road surface.
33 feet of easy-to-use Tarmac and Asphalt repair strip, will permanently repair cracks to prevent further deterioration of the paved surface. Can also be used when new tarmac is joined with existing to "weld" the joint lines
Just stick the tape firmly along the crack or joint and then heat with a standard propane torch, the tape will melt to the surface and seep down into the joint or crack to complete the "weld"
Polymer modified bituminous strip for use as an instant and PERMANENT waterproof seal for cracks or reinstatement joints. For use on both road pavements and secondary roads. The application of the tape prevents the ingress of water which causes cracking and severe fretting leading to the eventual breakdown of the asphalt pavement. The skid resistance can be increased by covering the tape with granite dust or kiln dried sand providing a non slip stone value similar to that of the existing road surface. Available from stock. 33 feet long rolls Features: Quick and easy- simple "torch-on" solution will give you a road repair that lasts. Waterproof- repair tape is waterproof so will prevent water ingress and freezing damage